AC Installation in Riyadh
Bad installation kills a new air conditioner within two years. We do it properly: correctly sized copper, full vacuum evacuation, and drain fall set right.
Most of the two-year-old units we repair did not break down — they were installed wrongly. Undersized copper, incomplete vacuum evacuation, or reversed drain fall all destroy a compressor slowly and void the manufacturer warranty.
How we install
We choose the best position for both units for drainage, airflow and future serviceability, run correctly sized and fully insulated copper, provide electrical supply on a suitable breaker, and evacuate the line set with a vacuum pump before releasing refrigerant.
Vacuum evacuation
Many installers skip this to save time. Air and moisture left in the circuit form acids that damage the compressor over time. We use a vacuum pump on every single installation.
Drainage
The condensate line must fall outward with adequate slope. Incorrect fall is the number one cause of water dripping indoors weeks after installation.
Handover
We run the unit, measure the temperature split across the coil and check pressures, and hand you the readings. On a new unit the manufacturer warranty stays intact because the installation was done to specification.
What is included
- Correct positioning for both units
- Properly sized, fully insulated copper
- Vacuum evacuation on every installation
- Electrical provision on a suitable breaker
- Drain fall set to prevent dripping
- Tested, with readings handed to you
AC down? Do not wait for summer.
Call or WhatsApp us. Send a photo of the unit and its data plate and we will tell you what it needs straight away.
Questions about this service
What determines how big an installation job is?
Three things: the copper line length, the height and accessibility of the outdoor unit position, and whether electrical provision already exists. Send us photos on WhatsApp and we will tell you what your installation needs before we come out.
Will you install a unit I bought myself?
Yes, to the same standard. We will tell you before starting if the capacity is wrong for the room size.
What capacity do I need for my room?
A working rule for Riyadh is around 700 BTU per square metre, increased if the room takes direct sun or has large windows. An oversized unit cools fast then cycles off, which raises humidity and uses more electricity.
How long does installation take?
Two to three hours for a single split unit under normal conditions.
Does installation affect the manufacturer warranty?
Incorrect installation voids it with most manufacturers. We install to specification and document the work so your warranty stays valid.
Other services
AC Repair & Maintenance
Not cooling? Tripping? Making a noise it never used to make? We come out, diagnose it by measurement, and in most cases fix it on the first visit — and we stand behind it.
Details →AC Cleaning & Washing
Riyadh dust suffocates an air conditioner. Regular washing restores cooling power and cuts your electricity bill more than most people expect.
Details →AC Removal & Relocation
Moving house? Don't let the movers touch your AC. A bad disconnect loses the refrigerant and kinks the copper — a far bigger problem than the move itself.
Details →